Digital Press Konica Minolta AccurioPress C14010S for Printing on Ceramic Cups!

step 1. Laser printing：

The printing settings of laser printers of different brands and models are not exactly the same. Please read the operating instructions of the laser printer carefully or consult the laser printer sales agent for laser printing settings.

step 2. Pre-coating：

Soak a sanitary napkin in the Pre-Coat FJ5 pretreatment liquid and gently wipe the laser-printed coating surface. Let it dry naturally for about 5 minutes.
Note: There should be no water droplets. If there are any, wipe them dry with a dry cotton ball.

step 3. Water slide：

Soak in warm water (water temperature is about 30~45 °C) for about 30~60 seconds, until the Pretty-Film (PF-150) can be easily separated from the based paper.

step 4. Remove bubbles

With the printed surface facing down, press the backing paper to separate it from the film, leaving the film on the tiles product. Press the film and gently slide it to a suitable position. Use a rubber melon or a wet towel (88.3% polyester/11.7% nylon fiber blends) to gently scrape the water droplets and bubbles between the film and the tile product.

step 5. baking：

Set the electric baking temperature to 130°C~145°C and the time to 5~8 minutes. The optimal temperature and time can only be determined after multiple tests.
ceramics tile products need to be heated up slowly to the required temperature to avoid sudden temperature changes and spontaneous explosion of the tile.
Put the ceramics tile in the electric oven, close the door, and adjust the time knob to 5~10 minutes. When the baking time is reached, open the oven door, put on high-temperature resistant gloves, take out the ceramics tile, and place the ceramics tile on a heat-resistant table.

step 6. Film tearing：

Let it cool naturally for about 30~60 minutes and start to tear off the film from the corners.

step 7. baking：

Set the electric baking at higher temperature to 170°C~190°C and the time to 5~8 minutes for Better colorfastness 

Precautions：

Please do not try to scrape, rub or pick at the finished product, as it needs to be left for at least 24 hours to achieve the best fastness.

Tiles absorb water very well, so please do not soak them in water to avoid producing a lot of bubbles during baking, which will cause goose bumps in the photos.