1. Print patterns by Eco-Solvent printers

2. Cut patterns by vinyl cutting plotters

3. Submerge you pre-cut decal in 30~55°C (Celsius) water for about 30~60 seconds or until the middle of the decal can easily slide around. Remove from water.

4. Slide the printed side up onto the crafts, and gently scrape away the water droplets and air bubbles between the printed side and the crafts with a damp towel (polyester/nylon blends) or soft rubber scraper

5. Let the decal set and dry for at least 48 hours. Don’t expose to direct sunlight during this time.

6. Spraying car clearcoat for better gloss, hardness, scrub resistance,washability, etc. you can use polyurethane varnish, acrylic varnish, or UV-curable varnish to spray coverage protection.

7. dry naturally, finished!

Note: 
1). If you want better gloss, hardness, washability, etc., you can use polyurethane varnish, acrylic varnish, or UV-curable varnish to spray coverage protection. 

2). It is preferred to spray clear automotive varnish to obtain better gloss, hardness, and scrub resistance

3). Towel is made of 88.3% polyester/11.7% nylon fiber blends，brushing